I need (from what I understand) either encore viewer or possibly an earlier version of encore pro such as V1.8.49 to access and decode the data. I just came across a NOS M series bipap and am currently using it. With the newer versions of software the card reads successfully, but the data is shown as invalid. Basic and pro will read the patient name and machine serial number, allow me to assign the card, change Rx to the machine, etc, but the data portion of the smartcards information needs to be decoded. I have tried encore basic and encore pro, but those programs will not read data from the smartcard - they are for SD cards. It appears as though he has helped others with this issue. Apparently I must either post or reply a certain amount of times before I am allowed to PM? Uncle_Bob I hope that you see this. I would like to contact Uncle_Bob for information to get the encore viewer software, but as a new member I am unable to PM him. You might check to see if they could possible get it overnighted to you to have it by Thursday but you would have to decide quickly. I am going to have the dreaded colonoscopy shortly. I am short on time or I would go look around for it. But I haven't looked either, so maybe someone here might be able to tell you if there is a place to download even if it did cost money. I am not aware of any place to download the new version (there never was for the old version of EncoreViewer either). If the new software is anything like the older version it doesn't present easily for obtaining other than by disc or a direct download from somewhere. While I have the older version of EncoreViewer that works with my M series machine, I do not believe it will work with the new machine. Link above is to the humidifier that goes with the new PR system one machine.

Respironics encore pro